|
|
| Installation
Instructions |
1
|
| Bracket
|
10
|
| Bolt
Pack |
1
|
|
|
| Measuring
Tape |
|
| Ratchet
wrench with ½" socket |
|
| Combination
wrench |
|
| Safety
Glasses |
|
| 25/64
drill bit and variable speed drill |
|
STEP
ONE: Mount brackets to pinchweld (Fig
A)
- (HD only) Find the 4 tabs that hang off the
pinchweld, You will hang the first three brackets
on the first three tabs using 1/4" bolt and
flange nut. Loosely bolt these to the vehicle
- The rear two brackets you will have to drill
through the pinchweld, but will mount the same way
as the firs three.
- All 1500 series (non HD) you will have to drill
through pinchweld a 1/4" away from the lip of
the pinchweld.
- Do this for each one of the brackets putting
them in the proper places.
STEP
TWO: Install top bolt into rocker panel
- You will need to mark a hole in the top slot
in the bracket
- Move bracket and drill the hole using a 25/64
drill bit
- Insert Teri-wai into hole that you drilled and
replace bracket.
- Take an 6mm bolt and insert through bracket into
Teri-wai
- Tighten down until snug, do this with all
brackets.
STEP
THREE: Attaching board to brackets.
- Slide bolts to line up with brackets, then tilt
board back and slide up under body letting the
rear bolts fall into slots first then the front
bolts .
- Push board in or out to desired location then
thread flange nut and tighten, do this with all
brackets .
- Check that all brackets are tight before
stepping on boards.
That’s
SHARP !!!
|
|
|
