|
|
| Running
Board |
2
|
| Installation
Instructions |
1
|
| Bracket
|
8
|
| Bolt
Pack |
1
|
| Light
Wiring Kit |
1 |
|
|
| Ratchet
wrench with ½" socket |
|
| Combination
wrench ½" |
|
| Safety
Glasses |
|
| Variable
speed drill w/ 3/8" hex head drive |
|
STEP
ONE: Determine proper bracket placement
- Find the pre-existing holes equally spaced on
the pinch weld.
- Drop5/16" bolt through stiffener plate and
pinch weld hand tighten both sides of the plate.
- On the first bracket the plate must sit on the
angled section of the rocker panel, It bolts the
same as the other three brackets.
STEP
TWO: Loosely attach brackets to stiffener plates
- Using an 5/16" bolt, bolt from the outside
in through the plate and bracket hand tightening
so it can slide up and down.
- Take another bolt and insert through top slot of
bracket and slotIn stiffener plate and into the
factory threaded hole, hand tighten.
- Place board on brackets allowing support bolts
to fall through slots in brackets, Slide in and
out to desired location and tighten using the
flange nuts that are provided
STEP
THREE: Securing stiffener plate to vehicle (Fig B)
- On the side of the plate without the bracket you
will need to tec screw through the plate and into
the rocker panel, repeat on all brackets.
- Push board tight against vehicle and tighten all
bolts.
- Check that all brackets are tight before
stepping on boards.
|
|
|
