STEP ONE: Remove step plate and panel
1) Remove the plastic door step plate by carefully pulling it up by hand.
2) Remove the plastic panel that is adjacent to the door and under the dash.
3) Expose the wires that are behind the panel and expose the light that is under the glove box.

STEP TWO: Run wire from boards into vehicle.
1) Run the wire from under the running board up behind the door hinge and through the rubber housing for the speaker wires. FIG A
2) Pull the wire inside the vehicle so there is no excess hanging in the door or under the running board. The plastic covering may be removed on the wires that are inside the vehicle. Fig B

STEP THREE: Attach Ground wires.
Fig B
1) Expose about 1/2" of the ground wires (white).
2) Expose about 1/2" of copper on the lights ground wire. (black)
2) Attach the running board ground wire to the white wire and seal it with butt connectors or electrical tape.

STEP FOUR: Attach positive wires.
Fig B
1) Expose about 1" of the positive wire from the running board. (red)
2) Expose about 1/2" of copper on the light's positive wire. (orange)
3) Attach the running board positive wire to the orange positive wire using butt connectors or electrical tape.

STEP FIVE: Replace Panels
1) Snap the side panels back on.
2) Snap the door kick plates back on.

Fig.A





Fig.B